|
BEC work under 3LIPO(10cell NIMh/NiCd)
5LIPO or 18
cells
NIMh/NiCd
MAX with BEC disabled
First,
connect the motor and receiver to the speed controller
Remove battery power from
the
speed
controller.
Turn on the
transmitter.
Move
throttle stick on full power position, (UP Position)
Reconnect battery power to
the
speed
controller
After 3sec
you can hear (all sound is 3times)
∮—
CELL Type AND Number
∮— —
BRAKE
∮— — —
TIMING MODE
∮— — — —
PWM
ON you need
programming menu, move the throttle stick to the middle position
1， CELL
Type AND Number
•—
NiMh/Nicd AUTO（0.8V/CELL*）
•— —
3LIPO （2.75V/CELL）
•— —
—
4LIPO（2.75V/CELL
•—
— —
—
5LIPO（2.75V/CELL）
*IF used 2LIPO you can use the option (select the NiMh/Nicd
AUTO)
2，
BRAKE
••—
NO
•••—
— SOFT
•••—
— —
MID
•••—
— —
HARD
3，
TIMING MODE
•••—
3º
••••—
— 8
º
•••••—
— —
15º
•••••—
— —
— 30º
4， PWM
••••—
8KHZ
•••••—
—
16KHZ
•••••••—
— —
32KHZ
IF the
option is you need, then move the throttle stick to UP position.
The long
BEEP is save the option. and the system will go to the programming menu.
You can
setup other options.
When all you need option is setup
OK, push the throttle stick to down position, after 1sec the system were
save all option, then you can start the motor now!! |
